Displaying Led Conditions - Paradyne 3150 Operator's Manual

3. Using the Front Panel

Displaying LED Conditions

The same conditions monitored by the front panel LEDs can also be monitored by
the LED command. This command is most useful when the CSU is being
accessed remotely (see
Panel Emulation, no LEDs are shown on the PC's screen; you must use the Stat
command procedure described below to get LED information.
Procedure
To display LED conditions on the front panel screen:
3-8
Appendix H, Front Panel Emulation
1. From the top-level menu screen, select Stat.
2. From the Status screen, press the
the screen.
3. From the Status screen, select LED.
Status:
TStat ENET
F2
F1
The LED Display screen lists the LED signals, two at a time, on the second
line. A vertical bar at the left of the LED name indicates the condition is ON,
while an underscore indicates the condition is Off.
LED Display:
_Test _NetSig
F2
F1
4. Use the and keys to scroll LED names onto the screen.
March 2001
key until the LED selection appears on
LED
F3
F3
). When using Front
3150-A2-GB24-10