T Configuring The Com Port Or Modem Port For Snmp Or; Telnet Access - Paradyne 3150 Operator's Manual

Configuring the COM Port or Modem Port for SNMP or

Telnet Access

To configure the COM port or Modem port for SNMP or Telnet access:
T
T
T
T
T
T
T
3150-A2-GB24-10
Enable the SNMP agent or Telnet server within the CSU (see
Configuration Options ).
Select and configure the port that provides the link to the SNMP or Telnet
system.
Set the Internet Protocol (IP) address and subnet mask needed to access the
CSU (see Appendix G, IP Network Addressing Scenarios
Select the link layer protocol (PPP or SLIP) for the port that provides the link to
the SNMP or Telnet system.
For SNMP links, specify the two community names (and their access levels)
that are allowed to access the device's Management Information Base (MIB).
For SNMP links, configure the device to send traps to the SNMP manager, if
desired.
Specify the Telnet password or SNMP validation options, if desired (see
Appendix C, Configuration Options
March 2001
).
).
4. Configuration
Appendix C,
4-11