Paradyne 3150 Operator's Manual page 130

C. Configuration Options
Table C-4. User Interface Configuration Options (2 of 10)
C-8
Password: None
Next None Com Modem
Password Mode. Activates a password prompt that prevents access until a password is
entered.
–
None Does not require a password.
–
Com Prompts the communications port user to enter a password.
–
Modem Prompts the remote modem port user to enter a password.
–
Both Prompts both the communications port user and the remote modem port user to
enter a password.
Com Port: Disab
Next Enab Disab Prev
Setting the Carrier Communication Port. Enables the use of the communication port in
carrier-mounted CSUs.
–
Enab This communication port is enabled.
–
Disab The communication port is disabled.
NOTE: This configuration option is available on carrier-mounted CSUs only.
Com Use: ASCII
Next Mgmt ASCII Term
Communication Port Use. Specifies how the communication port is used.
–
Mgmt Configures the communication port as the link to an SNMP or Telnet system.
–
ASCII Configures the communication port as a proprietary ASCII port supporting Front
Panel Emulation software and ASCII alarm messages. Only one ASCII communication
port is allowed per 3000 Series carrier.
–
Term Configures the communication port as the interface to an async terminal.
ComExtDev: Disab
Next Disab AT Other
Carrier Communication Port's External Device Commands. Specifies the communication
port's external device commands. When this configuration option is disabled, no
commands are sent out the communication port. Select AT to have standard attention
(AT) commands sent out the communication port to control the external device. Select
Other to configure the connect prefix, the connect indication string, the escape sequence,
the escape sequence delay, and the disconnect string.
–
Disab Allows no commands to be sent out the communication port.
–
AT Allows standard AT commands to be sent out the communication port.
–
Other Allows user configurable commands to be sent out the communication port.
NOTES:
– This configuration option is available on carrier-mounted CSUs only.
– This configuration option is not available if the communications port is disabled.
– Carrier Detect (CD) is used to detect that the external device's connection is lost.
Therefore, do not allow the CD lead to be forced on by the external device.
– The external device should be strapped to ignore Data Terminal Ready (DTR).
March 2001
Both Prev
Prev
Prev
3150-A2-GB24-10