Network Interface Configuration Options - Paradyne 3150 Operator's Manual

Network Interface Configuration Options

Table C-2. Network Interface Configuration Options (1 of 3)
3150-A2-GB24-10
NET Framing: ESF (Factory 1)
Next D4 ESF Prev
Network Line Framing Format. The framing format to be used on the network interface.
–
D4 Configures for the D4 framing format.
–
ESF Configures for the Extended Superframe format.
NET Coding: B8ZS (Factory 1)
Next AMI B8ZS Prev
Network Line Coding Format. The line coding format to be used on the network interface.
–
AMI Configures for the Alternate Mark Inversion coding format.
–
B8ZS Configures for the Bipolar 8 Zero Suppression coding format.
LBO: 0.0
Next 0.0 –7.5 –15
Line Build Out. The line build out (LBO) for the signal transmitted to the network (0.0 dB is
the factory default).
ANSI PRM: Disab
Next Enab Disab Prev
Generate ANSI Performance Report Messages. Specifies whether ANSI T1.403
compliant performance report messages (PRMs) are generated.
–
Enab Generates and sends ANSI PRMs over the FDL every second.
–
Disab Prevents the CSU from generating ANSI PRMs.
NOTE: This configuration option is only available if the framing format is set to ESF.
Mgmt Link: Disab
Next Enab Disab Prev
FDL Management Link. Specifies whether Facility Data Link (FDL) is enabled. Selecting
Enab allows SNMP or Telnet traffic to flow over the 4 kbps data link provided by FDL.
Running SNMP or Telnet over FDL requires an end-to-end FDL connection and cannot be
terminated within the network.
–
Enab Enables the FDL management link for SNMP or Telnet.
–
Disab Disables the FDL management link.
NOTES:
– This configuration option is only available if the framing format is set to ESF.
– If the local CSU's FDL is enabled, the remote CSU's FDL must also be enabled.
March 2001
D4 (Factory 2)
AMI (Factory 2)
–22.5 Prev
C. Configuration Options
C-3