Front Panel Indicators - Paradyne 6512 Installation Instructions Manual

Front Panel Indicators

All of the adapter's indicators turn ON and OFF during the power-on self-test. After a
successful power-on self-test, the adapter's indicators should appear as indicated in
BOLD in the Condition column of the following table:
Indicator Condition Status
PWR ON
ALM OFF
ON
TST OFF
ON
LINE ON
OFF
ETHERNET ON
OFF
Under normal operation, if the PWR and LINE indicators are on you should be able to
access the superline service to which you have subscribed. The ETHERNET indicator
state depends on the equipment you have connected to your adapter. The TST and
ALM indicators can be initiated by your Network Service Provider. For conditions other
than these, refer to Troubleshooting Your Adapter on page 22 for indicators requiring
action.
Power – Green
Alarm – Red
Test – Yellow
PWR ALM TST
TM
TM
Power is applied to the adapter.
No active alarms.
An alarm condition exists which may require further
attention. Refer to Troubleshooting Your Adapter on
page 22.
No active tests.
The TST indicator is ON during the power-on self-test and
during testing or upgrades initiated by your network
service provider. Superline service is not available when
the TST indicator is ON. Your existing (BASE) phone still
works.
Your adapter is connected to your local phone company
and is ready to use.
The link has not been established.
The Ethernet connection to your PC or Ethernet Hub is
made and your PC is ON.
No Ethernet device is detected.
7
Line – Green
Ethernet – Green
LINE ETHERNET
99-16016a-01