Table of Contents
Advertisement
User's Manual
Factory Reset Switch
CAUTION: When using the Factory Reset, you will lose any settings you have saved.
To reset the unit, you will need a straightened paperclip:
Turn the DVR off.
1.
Poke the straightened paperclip into the unlabeled hole to the left of the VGA port, and turn
2.
the DVR on.
Hold the reset switch until the DVR turns on and live monitoring screen appears.
3.
Release the reset switch. All of the DVR's settings are now at the original settings it had
4.
when it left the factory.
Video Out
Connect the main monitor to the Video Out connector.
A VGA connector is provided so that you can use a standard, multi-sync computer
monitor as your main monitor. Use the cable supplied with your monitor to connect
it to the DVR.
NOTE: The Video Out (BNC) and VGA connectors may be connected to individual monitors
for simultaneous operation.
Network Port
The DVR can be networked using the 10/100Mb Ethernet connector. Connect a
Cat5 cable with an RJ-45 jack to the DVR connector. The DVR can be networked
with a computer for remote monitoring, searching, configuration and software
upgrades. See Chapter 3 ─ Configuration for configuring the Ethernet connections.
CAUTION: The network connector is not designed to be connected directly with cable
or wire intended for outdoor use .
Alarm Input/Output
Alarm In 1 to 8 (Alarm-In): You can use external devices to signal the DVR to react to events.
Mechanical or electrical switches can be wired to the AI (Alarm-In) and GND (Ground) connectors.
The threshold voltage for NC (Normally Closed) is above 4.3V and for NO (Normally Open) is
below 0.3V, and it should be stable at least 0.5 seconds to be detected. See Chapter 3 ─ Configuration
for configuring alarm input.
4
The DVR has a Factory Reset switch to the left of the VGA port on the
rear panel. This switch will only be used on the rare occasions that you want
to return all the settings to the original factory settings.
NOTE: To make connections on the Alarm Connector Strip, press
and hold the button and insert the wire in the hole below the button.
After releasing the button, tug gently on the wire to make certain it is
connected. To disconnect a wire, press and hold the button above
the wire and pull out the wire.
Advertisement
Table of Contents
