Chapter 4 - System Overview; Service Manager; Menu - Eneo PNR-5104 Operating Instructions Manual

Chapter 4 — System Overview
The iNEX software consists of the following programs:
 Service Manager: Controls the operation of services or displays system log. Refer to 4.1 Service Manager
(p. 23) for details.
 Setup: Allows you to add service, devices and users, or set up recording schedules, event management
schedules and storage. Refer to 4.2 Setup (p. 28) for details.
 Client: Allows you to monitor video from registered cameras, play back recorded video from storage,
export recorded video and check the system log and devices' status. Refer to 4.3 Client (p. 33) for details.
NOTE: The following programs are provided apart from the iNEX program running (Go to the Start Menu
→ Click iNEX and then Utility).
– ProblemReporter or SecretKey: You will use them following the directions of your dealer or distributor
when your dealer or distributor requests.
– LanguageSelector: Use it to change the iNEX program's language.

4.1 Service Manager

NOTES:
 A "service" in the iNEX program is a process that runs in the background and performs a specified operation.
When the federation service is installed, the service runs in the federation server, and administration,
monitoring, streaming and recording services run in the NVR system. The services run automatically when
the server or NVR system turns on.
 The Service Manager program is supported in the federation server only.
Go to the Start Menu in the streaming or federation server → Click iNEX →
Run the Service Manager program.
Federation Server

Menu

 Operation: Starts or stops services. When the services are stopped, you cannot run the services and
Client program, and the system does not record. If you have changed any settings of the Service Manager
program, stop and restart services to apply the changes.
① Menu: Allows you to control the operation of the
services or display the system log.
② Status Display: Displays the status of services.
Network Video Recorder
21