Default Security Level - GE LOGIQ Totus Basic Service Manual

GE HealthCare CONFIDENTIAL
Direction 5936427, Rev. 1 LOGIQ Totus Basic Service Manual
3-5-8

Default security level

The Default Security Level dialog box displays when the software is initially installed and whenever the
software is reloaded. When the ADM user logs onto the LOGIQ Totus, the password level dialog will
display. This dialog will display every time the ADM user logs on until a level selection is made. If they
make a selection and then reload software, the level will be cleared and they will need to select the level
again.
To set the login security level:
• After boot up, log in as ADM (no password required) and, when prompted, select Lowest for the
security level.
NOTE: Select the Lowest security level and then continue with installation and testing.
After installation and testing is complete, transfer the LOGIQ Totus to the Site Administrator who can
reset the security level for the site.
The security level can be reset through Utility > Admin > Logon.
Refer to "Initial Login to the LOGIQ Totus" in the Basic User Manual (latest revision) for more
information.
Figure 3-10 Default Security Level Dialog Box
Chapter 3 LOGIQ Totus Setup 3 - 21