GE LOGIQ Totus Basic Service Manual page 248

Direction 5936427, Rev. 1
Monitor arm vertical adjustment
If the monitor rises or falls when it is released, perform a vertical adjustment.
Table 6-5
1.
Tilt the monitor down to access the vertical
adjustment screw.
2.
If the monitor was rising, turn the adjustment
screw clockwise to increase the friction,
using a 4 mm hex wrench.
If the monitor was falling, turn the adjustment
screw counterclockwise to decrease the
friction.
The monitor should stay in the position it is
released at.
NOTE: The heavier the monitor, the more
friction will be required.
6 - 12 Section 6-3 - Monitor Arm and/or Monitor Range of Motion Adjustment
GE HealthCare CONFIDENTIAL
Monitor Arm Vertical Adjustment
Step
LOGIQ Totus Basic Service Manual
Corresponding Graphic
Monitor Arm Vertical Adjustment Screw