GE LOGIQ Totus Basic Service Manual page 503

D 5936427, R
IRECTION EV
8-10-5 Replacement of the GPU Set-T
This table includes information specific to these instructions. For more information
for servicing the LOGIQ Totus" on page 8-5 /8-2-7 "PPE Required During Service" on page
Table 8-94
Manpower
One person
8-10-5-1 Preparations
1.) Power off/Shutdown the system as described in
2.) Remove the Rear Cover Mid Assy-T as described in
Assy-T" on page 8-138
3.) Remove the Rear Cover Top Assy-U as described in
Assy-U" on page 8-143
8-10-5-2 Removal Procedure
1. Unscrew 10 screws to remove the Unity Rear Shield
Brkt from the console.
Note: If the WLAN-T was installed, remove the
WLAN-T as described in
the WLAN-T and WLAN USB A Cable" on page
8-199
2. Unscrew 4 screws to remove the GPU Set-T.
8-10-5-3 Installation Procedure
1.) Parts to be installed in reverse order of removal
2.) Perform "Functional Checks after FRU replacement (Debrief Guideline)" as described in
12 on page 8-223
GE HealthCare CONFIDENTIAL
. 1
Manpower, Time, Tools, and PPE
Time
Approximately 15 minutes
Steps
8-11-13 "Replacement of
Section 8-10 - Replacing Back End Parts
LOGIQ T
Tools
Phillips screwdriver
1-7-2 "Lockout/tagout procedure" on page 1-25
8-8-10 "Replacement of the Rear Cover Mid
8-8-15 "Replacement of the Rear Cover Top
Corresponding Graphic
Basic Service Manual
OTUS
8-2-6 "Tools needed
8-6.
PPE
Cut resistant gloves
Knee Pad
Section 8-
8 - 177