Users - GE LOGIQ Totus Basic Service Manual

Direction 5936427, Rev. 1
3-5-10

Users

the Basic User Manual (appropriate version) for more information.
To add users:
1.) Navigate to Utility > Admin > Users.
2.) Select Add and enter the user details.
NOTE: You will need to edit the ID field from NewUser default. Do not push "Add" again until adding
another user.
NOTE: Touch Keyboard is available with User Defined Key. Please use it if you need to type any texts.
DO NOT include the following characters in a user ID: slash (/), dash (-), asterisk (*), question mark (?),
an underscore (_), ampersand (&), or blank spaces. Also, DO NOT set up Users with the same
initials/signifier.
3.) Enter password using the defined policies.
4.) If needed, select User Must Change Password. The user will be prompted to change the
password on the next logon.
5.) Under Group Membership, select the groups for the new user.
NOTE: The user password is system specific. If the user needs to access multiple systems the
password will need to be entered manually on each system.
Figure 3-12 Users Window
6.) Allow the system administrator to specify whether the user account is active, blocked or requires a
password change.
7.) Allow the system administrator to remove a user by highlighting the user ID, selecting Remove to
mark the user as inactive, and then selecting Remove again to remove user from the list.
GE HealthCare CONFIDENTIAL
Chapter 3 LOGIQ Totus Setup
LOGIQ Totus Basic Service Manual
3 - 23