Setting The Interface Parameters; Setting The Module Management Parameters - Dürkopp Adler D869 e-con Service Instructions Manual

Programming

17.4.31 Setting the Interface parameters

The interfaces can be used for the scanner. The parameter is active if a
scanner is connected.
It is possible to define additional settings for the interface. The possibilities
are explained in more detail in the table.
Icon
BDE

17.4.32 Setting the Module management parameters

You can make changes to the configuration and the allocation of the inputs
and outputs both at the DAC Flex control and at input and output modules
1 and 2.
If connected correctly, any additional modules or PCBs, e.g. the stepper
motor module, will appear for checking under Module management.
Fig. 98: Module management
Service Instructions D869 e-con - 00.0 - 09/2023
Menu items
Mode
Baudrate
Transmission rate of the scanner
Value range
• Value range
Off/Scanner
• Value range
009600 -
250000 [Bits/s]
145