Dürkopp Adler D869 e-con Service Instructions Manual page 42

Checking the eccentric for the feed dog movement
Proper setting
At a handwheel position of 187° the feed dog should stop when the
Manual bartack button (1) is pressed down at maximum stitch length.
To check the feed dog movement:
1. Execute the service routine Feed dog > Movement ( p. 14).
 The software is used to define the necessary presettings on
Fig. 29: Checking the eccentric for the feed dog movement
(4) - Manual bartack button
2. Check if the sewing motor is at approx. 187°.
3. Use the Manual bartack button (4) to check if the feed dog is at a
4. Adjust if necessary ( p. 41).
5. Tilt the machine head ( p. 18).
40
the machine.
④
standstill.
Performing the basic settings of the eccentrics
Service Instructions D869 e-con - 00.0 - 09/2023