Dürkopp Adler D869 e-con Service Instructions Manual page 223

Troubleshooting
9361
9362
9370
9371
9372
9910
9911
9912
9913
9914
9915
9916
9917
9918
9919
9920
9921
9922
9923
9924
9925
9926
9927
9928
9929
9930
Service Instructions D869 e-con - 00.0 - 09/2023
Code Type Meaning
Error Edge guide x-axis pcb is not
connected
Error Edge guide y-axis pcb is not
connected
Warning Scanner module not connected
Warning Scanner module 24 V Error
Warning Scanner module 5 V Error
Warning Sewing stop
Warning Power down
Warning Restart necessary
Warning Empty bobbin
Warning Reset
Warning Please Wait!
Warning Erase internal Memory
Warning Erase USB key
Warning No USB key present
Warning Sewing stop
Warning Referencing
Warning Show Message from QONDAC
Warning Service Stop
Warning Update required
Warning Security key generated
Warning Security Key changed!
Warning Please Confirm Reset
Warning Reset
Warning Referencing?
Warning Not enough thread available
Warning Empty bobbin
Corrective
• Check cable
• Perform software update
• Replace PCB
• Check cable
• Perform software update
• Replace PCB
• Check connection cables
• Perform software update
• Replace scanner module
• Check connection cables
• Check connected scanners
• Replace scanner module
• Stored analogue value for stroke
• Check tilt sensor on machine
• Check 24V
• Replace the control
• The control is switched off
• Switch off the control
• Please insert a full bobbin
• Remove USB key!
• Please wait and do not remove
USB key
• Delete the SD card. Continue with
OK; cancel with ESC
• Delete the USB key. Continue with
OK; cancel with ESC
• Please insert USB key
• Machine in stop mode for
threading the thread
• Please wait for motor referencing
• Show Message
• Check the Service Stop button
• Check 24V
• Replace the control
• Press OK for Restart or ESC for
cancel
• Creation of a security key on a
USB key
• Overwrite Security Key?
• Really reset?
• Reset successfully
• Press pedal backwards
(pedal position-2)
• Please insert a full bobbin
• Please insert a full bobbin
221