Adjusting The Winder Filling Quantity - Dürkopp Adler D869 e-con Service Instructions Manual

Bobbin winder

12.2 Adjusting the winder filling quantity

Proper setting
The winding process will stop automatically when the required filling
quantity of the bobbin is reached.
Fig. 65: Adjusting the winder filling quantity
(1) - Bobbin winder lever
To adjust the winder filling quantity:
1. Move the winder lever (1):
2. Check the winder filling quantity by carrying out a winding process
Information
To keep the thread from overflowing on the bobbin, observe the following
setting tolerances:
• Bobbin Ø 32 mm: Ø 31 ± 0.5 mm
• Bobbin Ø 28 mm: Ø 27 ± 0.5 mm
Service Instructions D869 e-con - 00.0 - 09/2023
①
②
• Filling quantity too low: loosen the threaded pin (2)
• Filling quantity too high: screw in the threaded pin (2)
and correct the setting if necessary.
(2) - Threaded pin
79