Dürkopp Adler D869 e-con Service Instructions Manual page 180

Test Material Thickness Sensor sub-item
Use this sub-item to test the functionality of the material thickness sensor.
Fig. 120: Test Material Thickness Sensor sub-item
(1) - Signal quality
Parameter
To test the material thickness detection:
1. Open the menu Service > Multi test > Test Material
2. Lift the sewing feet.
3. Place the sewing material under the sewing feet.
4. Lift the sewing feet.
 The signal quality (1) must display the value 1.
178
Signal quality
Foot height
Sewing foot stroke
Sewing foot pressure
Speed
Needle thread tension
Thickness Sensor.
Description
Signal quality of the sensor
indicates the height of the sewing foot lift for
the current sewing material
indicates the sewing foot stroke for the current
sewing material
indicates the sewing foot pressure for the current
sewing material
indicates the set speed
indicates the needle thread tension for the current
sewing material
Service Instructions D869 e-con - 00.0 - 09/2023
Programming
①