Table of Contents
Advertisement
The machine is equipped with a central oil-wick lubrication system.
The bearings are supplied from the oil reservoir.
For topping off the oil reservoir, use only lubricating oil DA 10 or oil of
equivalent quality with the following specifications:
• Viscosity at 40°C: 10 mm²/s
• Flash point: 150°C
You can order the lubricating oil from our sales offices using the following
part numbers:
Container
250 ml
1 l
2 l
5 l
18.2.1 Lubricating the machine head
Fig. 127: Lubricating the machine head
(1) - Refill opening
(2) - Maximum level marking
Proper setting
The oil level is between the minimum level marking (3) and the maximum
level marking (2).
To lubricate the machine head:
1. Check the oil level indicator at the inspection glass every day.
2. If the inspection glass lights up red, the machine is not sufficiently
3. If the oil level is below the minimum level marking (3): Pour oil through
194
supplied with oil.
the refill opening (1) but no higher than the maximum level marking (2).
Part no.
9047 000011
9047 000012
9047 000013
9047 000014
(3) - Minimum level marking
Service Instructions D869 e-con - 00.0 - 09/2023
Maintenance
①
②
③
Advertisement
Table of Contents
