Table of Contents
Advertisement
Fig. 37: Aligning the needle bar linkage sideways (2)
(7) - Arm shaft crank
(8) - Threaded pins
8. Loosen the threaded pins (8) on the arm shaft crank (7).
9. Move the needle bar linkage (6) sideways such that the needle pierces
10. Push the set collars (2) up against one another so that there is no axial
11. Tighten the threaded pins (1).
12. Tighten the screw (3).
13. Align the thread lever (9) in the middle of the slot (10).
14. Tighten the threaded pins (8).
Order
Then, check the following settings:
50
⑦
Make sure that the threaded pins (8) stay on the flat.
exactly in the center of the needle hole (5) for the feed dog.
play.
Make sure that the thread lever (9) does not collide with other parts
when moving.
• Distance between hook and needle ( p. 53)
• Looping stroke position ( p. 56)
Adjusting feed dog and needle bar linkage
⑩
⑧
(9) - Thread lever
(10) - Slot
Service Instructions D869 e-con - 00.0 - 09/2023
⑨
Advertisement
Table of Contents
