Dürkopp Adler D869 e-con Service Instructions Manual page 148

Configuration of the inputs
Here you can configure and allocate the inputs, allowing you, for example,
to activate functions of the machine via a manual push button from the
outside.
Each input can be assigned one of the following modes.
The modes described here are the same functions that can also be
assigned to the buttons on the machine arm ( p. 158) .
Mode
Bobbin Wind mode
Bartack suppression/activation
Manual bartack
Half stitch
Whole stitch
Pointing Position
Needle high
Needle cooling
Additional thread tension
Stitch length switching
Seam Center Guide
Light barrier
Operation lock active with contact
open
Quick stroke adjustment
Switch to next segment
2
Foot lighten position
Additional fullness
Tape tension
Puller
Operation lock active with contact
closed
Operation lock in seam
Trigger program selection
Program selection Bit B0 - B9
Short stitch
2
146
nd
edge guide position (gap)
nd
edge guide position (height)
Explanation/reference
Operating Instructions
Operating Instructions
 p. 142
Operating Instructions
Operating Instructions/ p. 134
Operating Instructions
Operating Instructions
Operating Instructions/ p. 140
 p. 141
Operating Instructions/ p. 125
Operating Instructions
 p. 138
Operating Instructions/ p. 135
 p. 141
 p. 141
Operating Instructions
Program selection by an external device
 p. 115
 p. 138
Service Instructions D869 e-con - 00.0 - 09/2023
Programming