Wiring The Controller Connector On The Sensor Head Connection Cable; Disassembly Procedure; Wiring Procedure - Panasonic HG-S Series User Manual

3.3 Wiring the Controller Connector on the Sensor Head Connection Cable

3.3 Wiring the Controller Connector on the Sensor Head Connection
Cable

3.3.1 Disassembly Procedure

1.
Slide the protective cover in the direction of the arrow.
2.
Press down on the wire insertion hole lever (white) with a flat-head screwdriver (tip width 2
mm or less), and remove the wire.

3.3.2 Wiring Procedure

1.
Using the "STRIP GAUGE" on the side of the unit, strip the wire so that the core wire length
is 7 to 8 mm, and twist the core wires several times.
2.
Using a flat-head screwdriver with a tip width of 2 mm or less, press down until the lever
(white) on the operation unit until the lever locks.
3-6 WUME-HGS-11