Panasonic HG-S Series User Manual page 142

5.3 Advanced Settings (
The information checked varies depending on whether the type is regular or air-driven.
Regular type
While the trigger input is ON, the function checks whether or not the spindle extends out fully
[whether the normal measured value (NORM.V) is lower than the set LOW set value].
If the measured value never drops below the LOW set value while the trigger input is ON, an
alarm occurs.
You can change the settings so that an alarm does not occur.
● This function can only be used when the measurement mode is set to a mode that has
external trigger input enabled in
Air-driven type
While the trigger input is ON, this function checks if the spindle has retracted fully or [the
normal measured value (NORM.V) is over the HIGH set value].
If the normal value does not exceed the HIGH set value even once while the trigger input is
ON, an alarm occurs.
You can change the settings so that an alarm does not occur.
5-70
)
"5.3.1 Hold Setting ( )".
WUME-HGS-11