● The tolerance setting (±) is only valid when 1-point teaching is ON.
● For the 1-point teaching method, refer to
■
Setting method
Setting
Tolerance (±) (TOL<±>)
5.2.6 Preset Value (
When performing preset, you can shift (add or subtract) to any preset value.
You can set the dimension of a master workpiece as a preset value and use this as a master
value (reference value).
When the preset value is set to "6.0000"
WUME-HGS-11
"4.2.3 Teaching
0 to 199.9999
)
5.2 Basic Settings (
Mode".
Setting range
)
Default value
0.1000
5-17