Connecting Controller And Sensor St4-A - Panasonic ST4 Instruction Manual

Panasonic ST4 Instruction Manual
The tightening torque should be 0.5N·m or less.
2. Mount the sensor on the mounting surface with M3 screws with washers.

2.4.3 Connecting Controller and Sensor ST4-A□

!
The emitter of the ST4-A□ (connector color: gray) has to be connected with the emitter
connector of the controller (connector color: gray). The receiver of the ST4-A□ (connector color:
black) has to be connected with the receiver connector of the controller (connector color: black).
CAUTION
•
Make sure to turn OFF the power before connecting disconnecting the
cables.
•
Securely tighten by hand the fixing ring on the emitter or receiver of the
ST4-A□.
•
If the fixing ring on the emitter/receiver of the ST4-A□ is tightened with pliers,
the connector may be damaged.
•
If the tightening torque is insufficient, the fixing ring on the emitter or
receiver of the ST4-A□ may loosen due to vibrations, etc.
SEN TRONIC
AG
Produkte, Support und Service
DANGER!
If you hook up the connectors incorrectly or mix connecting the
emitters and receivers, the device will not operate properly. This
may result in serious injury or death.
Rugghölzli 2
CH - 5453 Busslingen
2.4 Mounting and Removing
Tel. +41 (0)56 222 38 18
Fax +41 (0)56 222 10 12
31
mailbox@sentronic.com
www.sentronic.com