Disconnecting The Air Tube (Air-Driven Type Only); Air Circuit (Recommended) (Air-Driven Type Only); Attaching The Controller And Sensor Head Connection Cable - Panasonic HG-S Series User Manual

3.4.4 Disconnecting the Air Tube (Air-Driven Type Only)

1.
While loosening the air tube clamp, move it halfway through the air tube.
2.
Grasp the sensor head and pull out the air tube.
(Note 1) Take care not to lose the air tube clamp.

3.4.5 Air Circuit (Recommended) (Air-Driven Type Only)

● Create an air circuit like the one (recommended) shown in the figure below and, if necessary,
adjust the speed of the spindle with the speed control valve.
(Note 1) Supply clean air (free from moisture, oil, dust, or other foreign matter) to this product.
(Note 2) Air pressure may decrease, depending on the length of the air pipe from the air supply source or any
pneumatic components (such as needle valves, speed controllers, or mini-filters) that are added. Take
care to ensure that air pressure supply to the product is sufficient. Select pneumatic components
suitable for the supplied air pressure.
(Note 3) The 3-port solenoid valve and speed control valve have their respective mounting directions. Mount
each valve in their correct direction by referring to the above diagram.
(Note 4) A filter with a rated filtration of 5 μm or less and a mist separator with a rated filtration of 0.3 μm or less
are recommended.

3.4.6 Attaching the Controller and Sensor Head Connection Cable

Insert the controller connector on the sensor head connection cable into the connector for the
sensor head connection cable on the controller.
WUME-HGS-11
3.4 Connecting the Controller and Sensor Head
3-11