Panasonic HG-S Series User Manual page 174

6.1 SPECIFICATIONS
Type
Model No.
Tip deviation amount
Grounding method
Probe tightening
torque
Material
Weight
Standards
(Note 1) Measured at an ambient temperature of +20 °C unless otherwise specified.
(Note 2) In the case of low measurement force type (HG-S1010R / HG-S1110R), measurements were obtained
with products in standard configuration without rubber bellows.
(Note 3) Typical value near center of measurement.
(Note 4) Excludes damage and deterioration to rubber bellows due to external causes.
(Note 5) Typical value in a clean environment with no contact with dust or liquids such as water and oil.
(Note 6) Connect to an HG-SC series controller manufactured in February 2019 or later.
Sensor head (Air-driven type)
Measured at an ambient temperature of +20 °C unless otherwise specified.
Type
(Note 1)
Model No.
Position detection
method
Measurement range
(Note 2)
(Note 2)
Stroke
Downward
mount
Measu
ring
Upward
force
mount
(Note 3)
Side mount
6-6
10 mm type
General purpose
Low
Standard measuring
force
HG-S1010 HG-S1010R
35 µm (typical)
0.1 to 0.4 N⋅m (no force applied to main unit)
Body: Zinc, (HG-S1032/HG-S1050: Aluminum),
Holder: Stainless steel (HG-S1032/HG-S1050: Free-cutting steel) Spindle: Tool steel,
Probe: Ceramic, Rubber bellows: NBR (black)
Approx. 80 g
General purpose
HG-S1010-AC
With a seal cap With no seal cap
mounted
Optical absolute linear encoder method
(Note 4)
(Note 4)
(Note 4)
High precision
Low
Standard measuring
force
HG-S1110 HG-S1110R
Capacitor grounding
EMC Directive/EMC Regulations
With a seal cap
mounted mounted
10mm
10.5mm or more
(Note 4)
(Note 4)
(Note 4)
32 mm type 50 mm type
General purpose
Standard
HG-S1032 S1050
(Reference
value)
40 µm (typical)
Approx. 150 Approx. 180
g
High precision
HG-S1110-AC
With no seal cap
mounted
(Note 4) (Note 4)
(Note 4) (Note 4)
(Note 4) (Note 4)
WUME-HGS-11
HG-
(Note
6)
(reference
value)
g