Table of Contents
Advertisement
Turning on or off the light source
Turn on the light source to display content or view test patterns. Turn off the light to extend the life of
the light source.
•
To turn on or off the light source, in the right toolbar, select and hold Light.
If turning on the light source when the projector power is off, power is turned on automatically.
Allow the projector to cool down for 10 minutes after turning it off.
Activating marriage
After selecting the IMB type, you must install the IMB and complete marriage to display secure
content and to comply with the Digital Cinema Initiatives (DCI) specification. You cannot complete
marriage remotely.
For more information on marriage, refer to CineLife+ User Guide (P/N: 020-103073-XX).
You cannot complete marriage remotely because you must be able to press the Marriage button on
the input panel during the marriage process.
1. In the left navigation menu, select Service Setup > Marriage Setup.
2. Select Start and complete the Marriage Setup wizard.
3. Select Finish.
4. Verify the marriage ring is installed correctly and an anti-tamper alarm does not appear on the
touch panel.
Disposing of the product packaging
Once the product has been installed and set up, Christie recommends reusing or recycling the product
packaging according to your local regulations.
Completing the installation checklist
Complete the provided installation checklist (P/N: 020-103137-XX) and return it to Christie.
Cinema 2K-RGB Installation and Setup Guide–CP2415-RGB and CP2420-RGB
020-103259-01 Rev. 1 (10-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
27
Advertisement
Table of Contents
