Checking Printing Accuracy - Stratasys J3 Series User Manual

Stratasys J3 Series User Guide

Checking Printing Accuracy

If there are printing-accuracy issues, as explained below, you can check if the
printing process (in the printer software) is aligned to match the exact position
of the print heads installed. With the Printing Accuracy Validation wizard, you
can determine if you need to run the
Indications of misaligned print heads are lack of color consistency, jagged lines
and other flaws in printed models.
Printed models with sections that are missing usually indicate clogged
nozzles in heads, or heads that are not functioning well together. If this is
the case, you need to run the
To check printing-accuracy:
1. Prepare a sheet of pink test paper.
2. From the Wizards screen, select Printing Accuracy Validation.
3. In the opening wizard screen, click Start to begin.
4. When the following screen appears, lock the build tray to prevent it from
5. Release the build-tray lock and tap Next.
DOC-19001 Rev. G
moving, and tape the test paper to the tray as shown.
Figure 4-97 Preparing for the printing accuracy check
4 Operating and Maintaining the Printer
Head Calibration
Head Optimization wizard.
wizard.
4-66