Stratasys J3 Series User Manual page 51

Stratasys J3 Series User Guide
8. Tap OK.
9. After replacing materials in all of the required channels, note the estimated
If you continue, you must complete the material replacement process
before you can print models. To replace material cartridges at another time,
tap Cancel. If you continue (by tapping Next) and you do not complete the
process, you will need to run the wizard again before printing.
10. After tapping Next, follow the instructions in the wizard screens.
To complete the material replacement process:
When replacing printing materials (Model and Support) with other printing
l
materials, the printer prints a model in the shape of an arc.
When replacing printing materials with cleaning fluid, the printer purges.
l
DOC-19001 Rev. G
The main material replacement screen appears again, where you can
select another channel.
Replacing certain materials requires print-head optimization. If this is the
case, Head Optimization is selected automatically in the material
replacement screen.
Figure 4-33 Head Optimization required
Note: If selected, run the Advanced Head Optimization wizard after
completing the Material Replacement wizard, before printing.
replacement time, and tap Next.
4 Operating and Maintaining the Printer
4-23