Stratasys J3 Series User Manual page 34

Stratasys J3 Series User Guide
A graphical representation of the cartridges loaded and their current weight
appears in the user interface.
Figure 4-9 Materials screen, showing cartridges
To display this screen, tap the Materials icon on the left, as shown.
This screen displays the total amount of material available for each channel.
To load printing materials after printer installation and after a long
shutdown, use the Material Replacement wizard.
Important: If you need to replace the printing material currently installed with
another type, see "Changing Printing Materials" on page 4-19. Otherwise,
make sure to replace the material cartridge with one containing the same type
of material.
To load model and support material:
1. Load model and support cartridges into their respective compartments.
2. The printer interface displays the new cartridge after a short delay. Check
DOC-19001 Rev. G
Figure 4-8 2 different materials in M1 and M2, support in M3 and S
Note: Make sure that the cartridges contain at least 50 grams of material.
Note: Repeated piercing of the cartridge seal can cause leakage. To avoid
leakage from the seal, do not pierce the seal more than 10 times.
the interface to make sure that the correct material is detected and that its
weight is displayed.
4 Operating and Maintaining the Printer
4-6