Table of Contents
Advertisement
Stratasys J3 Series User Guide
4. In the following screen, select Print transparency for analysis.
5. Make sure that the build tray is clear and clean, and confirm this in the
6. When the following screen appears, open the printer and remove the cap
DOC-19001 Rev. G
Figure 4-100 Wizard process selection
wizard screen.
Figure 4-101 Preparing for head calibration
When you tap Next, a frame is printed in the center of the build tray.
from the center of the build tray (see below). Then, place the blank
transparency sheet in the printed frame, and secure it with tape.
Figure 4-102 Fixing the transparency to the tray
4 Operating and Maintaining the Printer
4-69
Advertisement
Table of Contents
