Table of Contents
Advertisement
Stratasys J3 Series User Guide
5. To change the material in a channel, replace the cartridge(s) for that
DOC-19001 Rev. G
Three print head setup options are available, as shown below.
Figure 4-31 Model material loading options for Long Print mode
Tips for Long Print mode:
A support cartridge must be loaded in the S channel.
l
If an additional support cartridge is needed, it must be loaded in the M3/S
l
channel.
In this mode, you cannot use Elastico materials.
l
When loading the channels with 2 different model materials and 1
l
support cartridge, M1 and M2 must be loaded with the same model
material. See
Option 2
page 4-5.
channel.
4 Operating and Maintaining the Printer
in "Loading Model and Support Cartridges" on
4-21
Advertisement
Table of Contents
