Stratasys J3 Series User Manual page 89

Stratasys J3 Series User Guide
Installing the New Head
16. Place four (4) new O-ring seals in the replacement head (see Figure 4-85
17. Place a cleaning cloth on the build tray and place the head on it, as shown
18. Take the print-head-driver installation tool and insert it, from above, through
DOC-19001 Rev. G
on the previous page).
below.
Figure 4-87 New print head before installation
the opening in th eprint block.
Figure 4-88 Inserting the print-head-driver installation tool
4 Operating and Maintaining the Printer
4-61