Changing Printing Materials - Stratasys J3 Series User Manual

Stratasys J3 Series User Guide

Changing Printing Materials

Before producing models using a different type of printing material than is
currently installed, run the Material Replacement wizard to flush the print block
and feed tubes.
To replace the printing materials:
1. From the Wizards screen, tap Material Replacement.
2. In the opening screen, tap Start.
3. To change the print mode, in Print Mode, tap >.
DOC-19001 Rev. G
The main material replacement screen shows the materials currently
loaded in each of the Model channels (M1–M3) and in the Support channel
(S).
Figure 4-28 Initial Material Replacement screen (sample)
4 Operating and Maintaining the Printer
4-19