Stratasys J3 Series User Guide
Resuming Production After Printing has Stopped
If the printing process is interrupted, the print manager stops sending slices to
the printer. This can happen, for example, if the printing material runs out in the
middle of a print job, and you do not replace the empty cartridge immediately.
After the printer changes to Idle mode, you need to resume printing, either from
the printer or from GrabCAD Print Job Manger.
After printing stops, the printer goes into Idle mode, when heating of the
print heads is reduced.
To continue printing from GrabCAD Client :
1. Open the Schedule screen of GrabCAD Print.
Figure 4-22 Opening the Schedule screen
2. Locate the stopped job.
Figure 4-23 Stopped job in the Schedule screen
3. Click on the job to display the job details, and click the Resume icon
DOC-19001 Rev. G
OR—
Right-click on the job to display the pop-up menu, and select Resume job.
4 Operating and Maintaining the Printer
.
4-15