Stratasys J3 Series User Guide
14. Follow the remaining wizard screens to complete the procedure.
Replacing the Roller Waste Collector
A maintenance reminder appears when you need to replace the roller waste
collector. Replacement is necessary after 500 hours of printing or 4 months.
You should replace the unit earlier if it does not effectively keep the roller clean.
To replace the roller waste collector:
1. Prepare—
2. Open the printer and locate the roller waste collector, next to the roller.
DOC-19001 Rev. G
After replacing the wiper, you determine if it needs to be adjusted to wipe
the print heads effectively. You do this by looking to see if there is a gap
between the print heads and the wiper, and indicating this in the wizard
screen.
Figure 4-64 Wiper adjustment selection
❒ disposable cleaning gloves
❒ 90% isopropanol (IPA—isopropyl alcohol) or ethanol (ethyl alcohol)
❒ cleaning cloth
Figure 4-65 Roller and waste collector
4 Operating and Maintaining the Printer
4-47