Shutting Down The Printer - Stratasys J3 Series User Manual

Stratasys J3 Series User Guide

Shutting Down the Printer

You only need to shut down the printer if it will not be used for more than 10
days. Otherwise, the printer can remain on, in Idle mode. However, if there is a
need to turn off the printer sooner, use the Shutdown wizard to automatically
perform the necessary processes before turning off the printer.
To properly shut down, the printer needs to perform several processes,
depending on the length of time that the printer will not be used. These are
controlled by the Shutdown wizard. Unless you are unable to run this wizard
(because of a software error), do not shut down the printer by simply turning off
the power at the switch or by disconnecting the power to the printer.
Caution
Turning off the printer for an extended period without first running the wizard
can cause serious damage to print heads and other expensive printer parts.
Depending on the length of time the printer will not be used, you can choose
the most appropriate shutdown procedure.
• Up to 10 days: The wizard powers-down the printer without draining the
• 10 to 30 days: The wizard empties the print block of Model and Support
• More than 30 days: The wizard empties the print block, then flushes the
When shutting down the printer for more than 24 hours, printing materials
are drained from printer components. To avoid wasting valuable material,
plan to print models at least once a week. Many printer operators use this
opportunity to print customer samples or test models.
To run the Shutdown wizard:
1. From the Wizards screen, select Shutdown or press the printer power
2. Select the option corresponding to the length of time that the printer will not
3. In the next screen, verify that the tray is empty and click Next.
DOC-19001 Rev. G
print block. Use this option if you need to turn off the printer for servicing.
material to prevent leaks and to protect the print heads. This takes about 10
minutes.
system with cleaning fluid. This takes up to 35 minutes, and you must be
present to load cleaning-fluid cartridges when instructed.
button for 2 seconds (not more).
be used.
Note: Before selecting More than 30 days, make sure that four (4)
cleaning-fluid cartridges are available, each containing a minimum of 250
grams.
The shutdown procedure begins.
4 Operating and Maintaining the Printer
4-25