Table of Contents
Advertisement
Stratasys J3 Series User Guide
3. Pull the waste collector down to remove it,
Warning:
The scraper blade in the roller waste collector is sharp.
Use caution when handling the unit.
4. Soak a cleaning cloth with IPA (isopropyl alcohol) and clean the roller.
5. Install the new roller waste collector.
After replacing the waste collector in the printer, reset the maintenance
reminder in the software:
1. From the Wizards screen, select Preventive Maintenance.
2. In the opening wizard screen, click Start to begin.
3. In the next screen, select Roller Waste Collector.
4. In the following screen, select the confirmation check box.
DOC-19001 Rev. G
Figure 4-66 Roller waste collector
Figure 4-67 Replacement confirmation
4 Operating and Maintaining the Printer
4-48
Advertisement
Table of Contents
