Stratasys J3 Series User Manual page 102

Stratasys J3 Series User Guide
9. When scanning is finished, select Scan other images in the dialog box
If this dialog box does not appear, click Preferences (at the bottom of the
interface) and in the Scan tab, select Display the dialog to select next
action.
10. Remove the transparency from the scanner, and place the reference (grid)
11. Click Scan.
12. When scanning is finished, select Retouch and save the image in the
DOC-19001 Rev. G
and click OK.
Figure 4-111 Selection after scanning the test pattern
transparency on the scanner platen, next to the bottom and left borders.
Note: Do not adjust the cropping frame (scan area). The scanning size
must remain the same as for the test-pattern scan.
dialog box and click OK.
Figure 4-112 Selection after scanning the reference transparency
4 Operating and Maintaining the Printer
4-74