Stratasys J3 Series User Manual page 91

Stratasys J3 Series User Guide
21. In the printing chamber, place the securing brackets under the print head,
22. Tighten the securing screws on both sides of the print head.
Important:
Make sure not to tighten the securing screws more than necessary.
Be careful not to damage the surface (orifice plate) of the print head.
DOC-19001 Rev. G
then raise the head into place.
Figure 4-91 Positioning the bracket under the print head
Figure 4-92 Securing the print head to the print block
4 Operating and Maintaining the Printer
4-63