Starting Printing - Stratasys J3 Series User Manual

Stratasys J3 Series User Guide
3. Make sure that there is sufficient model and support material loaded, as
For loading material cartridges and replacing empty ones, see "Loading
Model and Support Cartridges" on page 4-5.
For changing the type of material currently loaded, see "Changing Printing
Materials" on page 4-19.

Starting Printing

There are several ways to start printing a job. You can:
• Send a job to the printer from GrabCAD Print.
• Reprint a recent job from the History screen.
• Load an .objzf file from a USB flash drive.
Sending a Job from GrabCAD Print
You can set up the printer so that it is ready to begin printing when a job is
received from GrabCAD Print.
To send a print job from GrabCAD Print:
1. When the printer is in Idle state, tap Ready to Print.
DOC-19001 Rev. G
indicated on the printer interface (see . You may want to replace the
cartridges of model and support material currently loaded in the printer to
avoid the need for replacing them during printing.
Note: When you click Print in GrabCAD Print, a warning message appears if
there is not enough of one or more material.
Note: Only.objzf files can be loaded with a USB flash drive
Figure 4-12 Home screen, Idle state, no jobs in queue
4 Operating and Maintaining the Printer
4-9