Stratasys J3 Series User Manual page 79

Stratasys J3 Series User Guide
8. When the Pattern Test is completed, remove the sheet from the printer.
9. Make sure that the build tray is clear and close the print door and tap Next.
10. Inspect the test paper for missing line, which indicate clogged nozzles.
11. In the following screen, enter the number of missing nozzles for each print
12. Continue as follows:
13. Place the scale on the build tray within the frame.
14. Follow the instructions in the wizard to set up the scale in the printer.
15. Place the resin container on the scale.
DOC-19001 Rev. G
Figure 4-70 Test print on the pink paper
head, then tap Next.
Figure 4-71 Recording test results
❒ If the number of missing (clogged) nozzles is not acceptable, follow the
instructions in the wizard.
❒ If the number of missing (clogged) nozzles is acceptable, the printer
continues to print-head optimization and prints a frame on the build tray
for positioning the scale.
4 Operating and Maintaining the Printer
4-51