Table of Contents
Advertisement
Stratasys J3 Series User Guide
6. When the following screen appears, open the printer and remove the test
7. Carefully inspect the test paper.
DOC-19001 Rev. G
paper.
Figure 4-98 Test printing finished
When you select the confirmation check box and tap Next, the wizard ends.
Calibration is necessary if you can see that patches printed by different
heads are not aligned.
Figure 4-99 Left: Calibrated heads Right: Heads needing calibration
To calibrate head alignment, run the
4 Operating and Maintaining the Printer
Head Calibration
wizard.
4-67
Advertisement
Table of Contents
