Stratasys J3 Series User Manual page 101

Stratasys J3 Series User Guide
5. Place the test-pattern transparency face-up on the scanner platen, so that
6. At the bottom of the scanner interface, click Preview.
7. With the cursor, adjust the cropping frame (scan area) so that the area
8. Click Scan.
DOC-19001 Rev. G
the arrow on the transparency is near the arrow on the scanner (in the
lower-left corner).
Make sure that the bottom and left edges of the transparency are at the
borders of the platen.
Figure 4-108 Placing the transparency on the scanner
Figure 4-109 Scanner interface, showing Preview and Scan buttons
beyond the transparency is not scanned. Make sure that the entire area of
the transparency is in the area to be scanned.
Figure 4-110 Adjusting the cropping frame (scan area)
4 Operating and Maintaining the Printer
4-73