Table of Contents
Advertisement
Stratasys J3 Series User Guide
4. In the following screen, select Load the calibration parameters from
After loading the parameters generated by GrabCAD Print, they are deleted
from your computer. Therefore, you can only apply them once.
Transferring the Calibration File Manually
If the GrabCAD client (the computer running GrabCAD Print) does not have a
connection to the printer, transfer the calibration file to the printer computer, as
follows:
1. On the GrabCAD client used for scanning the transparency, open the folder
2. Copy the file Parameters.csv to a USB flash drive or to a shared folder on
3. If you are using a USB drive, insert the flash drive to the USB port on the
4. Start the Head Calibration wizard.
DOC-19001 Rev. G
GrabCAD Print.
Note: If the printer and the GrabCAD client are not connected via the same
network, select Load the calibration parameters previously saved.
Figure 4-119 Loading the new calibration parameters
When you tap Next, the new calibration parameters are applied to the
printer software.
Note: If the calibration file was not transferred to the printer computer from
GrabCAD Print, the screen shown above does not appear. See
"Transferring the Calibration File Manually" below.
C:\Users\username\AppData\Roaming\Stratasys\GrabCADPrint\
GCPrint\tmp.
your local network.
printer.
4 Operating and Maintaining the Printer
4-79
Advertisement
Table of Contents
