Table of Contents
Advertisement
Stratasys J3 Series User Guide
10. With the alcohol-soaked cleaning cloth, clean the wiper and the
11. Close the purge unit.
12. With the alcohol-soaked cleaning cloth, carefully clean the UV light.
13. Clean the build tray.
14. Select the confirmation check boxes in the wizard screen.
15. Remove the cleaning materials from the printer, and click Next.
DOC-19001 Rev. G
b. Pull the securing latch up and open the purge unit.
Figure 4-48 Opening the purge unit
surrounding area.
Make sure to remove printing material from both sides of the wiper.
If the wiper is scratched, torn or worn, or if you cannot clean it completely,
you need to replace it. Do this with the
completing this wizard.
4 Operating and Maintaining the Printer
Wiper Replacement wizard
after
4-37
Advertisement
Table of Contents
