Stratasys J3 Series User Manual page 80

Stratasys J3 Series User Guide
16. Verify that the print heads are exactly above the resin container and tap
17. When done, remove the resin container from the printer.
18. Discard of the resin in accordance with your local regulation.
19. Remove the scale and its cable from the printer.
20. Place the resin container on the build tray within the frame to cure the
21. When done, remove the resin container from the printer.
22. Using a scraper, remove the printed frame from the build tray.
23. Wet a wiping cloth with isopropanol and clean the build tray.
24. Confirm in the wizard and tap Next.
25. In the results screen, tap Next to complete the wizard.
Troubleshooting a Scale Connectivity Error for the WTC600/POU Scale:
If you experience a Scale Connectivity Error, verify that the scale is connected
to the USB cable, and then configure the scale, as follows:
1. Press
2. Press
3. Press
4. Press
5. Press
DOC-19001 Rev. G
Next.
Printing material (resin) is jetted from each head and its weight is
automatically recorded.
remaining excess resin and tap Next.
Note: You can re-use the resin container several times.
Figure 4-72 Head optimization results
and to access the main menu.
a few times until P5.ducE is displayed.
. 5.1.PC is displayed.
until 5.1.1.Prt is displayed.
. r51 is displayed.
4 Operating and Maintaining the Printer
4-52