Stratasys J3 Series User Manual page 48

Stratasys J3 Series User Guide
4. Select the print mode and tap OK.
DOC-19001 Rev. G
❒ HiQualSpeed
❒ LongPrint
The displayed print modes depend on the printer type.
Figure 4-29 Selecting a print mode (sample)
High Quality Speed
This mode enables you to produce 3D prints with 3 model materials. Each
print head section is loaded with a different material.
Figure 4-30 Three model materials loaded in the print heads
Tips for High Quality Speed mode:
You cannot switch directly between Digital ABS™Plus and Elastico™ materials.
To switch between these materials, you must first perform material replacement
using another material, such as a Vero material, and then perform material
replacement to the desired material.
Long Print
This mode enables you to load more cartridges of a single material thereby
significantly reducing the need to replace cartridges during the print job.
The cartridges of the material you wish to print without replacing must be
loaded in the channels of the same print head.
4 Operating and Maintaining the Printer
4-20