Operating & Maintaining the Objet24 3D Printer
Cleaning and
Replacing the
Roller Waste
Collector
6–26
Normally, you do not have to inspect and clean the roller waste collector.
This is done by a customer‐support engineer during regular maintenance
visits. Occasionally, however, a blockage or damaged scraper may cause
material leakage on the build tray. If this happens, remove the roller waste
collector to inspect it.
To remove the roller waste collector:
1. Start the Head Cleaning wizard from the Options menu (see figure 6‐28
on page 23).
This wizard prepares the printer for removing the roller waste
collector.
2. When the following screen appears, confirm that the tray is empty and
that the printer cover is closed, then click
Figure 6-33: Wizard confirmation screen
The print block moves to the center of build tray, and the tray lowers.
3. When the following screen appears, open the cover.
Figure 6-34: Wizard screen that appears when you can begin the procedure
WARNING: The print head orifice plates (bottom surface) may be hot.
Do not touch them with your bare hands, and proceed with caution.
4. Put on protective gloves.
.
Next
DOC-34014 Rev. C