Stratasys J826 User Guide
6. Before returning the roller waste collector to the print block, make sure
To re-assemble the components:
1. Return the roller waste collector to the print block and screw on the
2. Loosen the screws securing the suction tube.
3. Lower the suction tube so that the hole in the panel behind the tube is
4. Attach the right-UV-lamp assembly to the print block and reconnect the
Replacing the
You should replace the roller scraper blade—
Roller Scraper
• after 1,000 hours of printing.
• if it does not effectively keep the roller clean.
You should periodically test the effectiveness of the roller scraper when you
clean the roller waste collector. See "Cleaning the Roller Waste Collector and
Inspecting the Roller Scraper" on page 4-40.
DOC-28000 Rev. D
that the pins are clean.
Figure 4-52 Roller waste collector pins
covering (see Figure 4-50 on the previous page).
Figure 4-53 Positioning the suction tube
visible, and tighten the screws to secure the tube.
UV power and fan cables.
4 Operating and Maintaining the Printer
4-43