Resuming Production After Printing Has Stopped - Stratasys Objet30 User Manual

Objet30 User Guide

Resuming Production After Printing has Stopped

If the printing process is interrupted, the print manager stops sending slices to
the printer. This can happen, for example, if the printing material runs out in the
middle of a print job, and you do not replace the empty cartridge immediately.
After the printer changes to Standby or Idle mode, you need to resume printing
from the print manager (in Objet Studio or in GrabCAD Print).
After printing stops, the printer goes into Standby mode, when heating of
the print heads is reduced. About 20 minutes later, the printer goes into Idle
mode, when heating of the print heads is stopped.
To continue printing the model :
1. If the printer is in offline mode, switch it to online mode by clicking the red
2. If you don't know why printing has stopped, make sure that the connection
3. In the Manager screen of Objet Studio, or in the Schedule screen of
4. In the Continue from Slice dialog box that appears, confirm the slice
DOC-34025 Rev. I
button at the bottom of the printer interface (see the figure on page 6-4).
The button changes from red to green.
between the printer and the server computer is active.
GrabCAD Print, click the Resume icon—
Note: To display the Resume icon in GrabCAD Print, click on the job in the
Schedule screen.
number, after checking the printer interface.
6 Operating and Maintaining the Printer
or .
6-15